搜搜做题作业网英语翻译#149 Design of Hole Punching Dies (9) Design of the Back
来源：学生作业帮 编辑：搜搜做题作业网作业帮 分类：英语作业 时间：2024/04/27 14:36:46
英语翻译
#149 Design of Hole Punching Dies (9) Design of the Backing Plate
Category :Shear Forming March15,2013
A force equivalent to the machining force acting on the punch is also generated on its back face.This force is received from the face of the punch holder,etc.
In the case of a punch with a small cross-section,as shown in Fig.1,this force cannot be received sufficiently by the surface of the holder and the punch may dig in to the plate.
In the case of a punch with a small cross-section,as shown in Fig.1,this force cannot be received sufficiently by the surface of the holder and the punch may dig in to the plate.In the case of a punch holder material such as S50C that is used without heat treatment,as a guide,when the average surface pressure on the back face of the punch (the load per unit area when the force is considered to be received by uniformly distributing the machining force over the surface of the punch flange) becomes more than 16Kg/mm2,the punch is likely to dig into the punch holder.
#149 Design of Hole Punching Dies (9) Design of the Backing Plate
Category :Shear Forming March15,2013
A force equivalent to the machining force acting on the punch is also generated on its back face.This force is received from the face of the punch holder,etc.
In the case of a punch with a small cross-section,as shown in Fig.1,this force cannot be received sufficiently by the surface of the holder and the punch may dig in to the plate.
In the case of a punch with a small cross-section,as shown in Fig.1,this force cannot be received sufficiently by the surface of the holder and the punch may dig in to the plate.In the case of a punch holder material such as S50C that is used without heat treatment,as a guide,when the average surface pressure on the back face of the punch (the load per unit area when the force is considered to be received by uniformly distributing the machining force over the surface of the punch flange) becomes more than 16Kg/mm2,the punch is likely to dig into the punch holder.
分数太少 虽然分数没用 可是你也太看不起英语的价值了吧 何况还是模具英语
英语翻译#149 Design of Hole Punching Dies (9) Design of the Back
英语翻译Design for the $10000club of counties and design for the
英语翻译1.Mechanical design means the design of things and syste
英语翻译英语翻译：The department of craetive design.semir.since 1996.
英语翻译The students of the Fashion Design Department at Weihua
英语翻译Recently,in the design of hydraulic system,how torealize
英语翻译The design,construction,operation and maintenance of a n
英语翻译The design of an earth or rockfill dam continuesthrough
英语翻译A.The design of an Information Based Manufacturingframew
英语翻译The standard of design and maintenance within our campus
英语翻译Informing the Design of an Information ManagementSystem
英语翻译The design of a package intended for liquid radioactive